Gas Pros Inc. sets and connects gas appliances for homeowners and builders across Hillsborough County: ranges and cooktops, dryers, tankless and tank-type water heaters, furnaces, grills, fire pits, pool heaters, and generators. If it burns gas, we connect it, with a properly sized line, the right shutoff, and a leak test before we light it.
Appliance connections are where gas work goes wrong most often. A range connected to an undersized line sputters under load; a water heater with the wrong venting or regulator setup is a safety problem. Our installations start by verifying the supply can actually feed the appliance, and end with a test-fire.
What gas appliance installation involves
Every connection follows the same discipline: confirm the line serving the appliance can carry its BTU demand, install or verify the shutoff valve, set the regulator where the appliance needs one, connect with approved flex connectors or hard pipe, leak-test every joint, and test-fire the appliance to confirm flame and operation. Gas water heaters add venting checks, because a water heater that drafts wrong is a carbon monoxide problem, not a comfort problem.
- Verification that the existing gas supply can carry the new appliance's BTU load
- Shutoff valves, regulators, and approved connectors installed where required
- Ranges, cooktops, dryers, and oven hook-ups
- Tankless and tank-type water heater connections, with venting verified
- Grills, fire pits, patio heaters, and outdoor kitchen appliances
- Pool and spa heater connections
- Leak test and test-fire before we leave
What to expect
We coordinate with your delivery or builder schedule so the connection happens when the appliance is actually on site. The gas is off during the hookup, and we re-light and check every appliance on the affected line. For new construction, appliance connections are the final phase after the gas system has passed its rough inspection.
Permits and inspections in Hillsborough County
Most appliance connections that add or change gas load require a permit. We pull it, City of Tampa Construction Services inside city limits, Hillsborough County Development Services in unincorporated areas, before the work, and the installation is inspected the same way a new gas line would be: pressure test where required, then final inspection after the appliance is set and firing.
Gas Appliance Installation — Common Questions
Who can install a gas appliance in Florida?
A licensed contractor performs the gas piping and connection work. Gas Pros Inc. is a licensed LP gas contractor working in Hillsborough County, and we handle the piping, connection, permit, and inspection as one job.
Can I switch from an electric appliance to gas?
Yes, if gas is available at the property. The switch usually means running a new line first, sized for the appliance, then connecting and testing the appliance. We do both parts in sequence.
How much does gas appliance installation cost in Tampa Bay?
It depends on the appliance, whether the existing line can serve it or a new run is needed, and the permit requirements. We quote the full job after seeing what's there, and the estimate is free.
Does gas appliance installation need a permit?
Usually yes. Connections that add gas load or change the system are permitted work. We pull the permit and schedule the inspection as part of the installation.
Do you install tankless water heaters?
Yes. We connect the gas side of tankless and tank-type water heaters, size the line for their high BTU input, and verify venting on indoor units.
Gas Pros Inc. connects appliances across Hillsborough County, from a single range hookup to a full new-construction appliance package.
(813) 425-3565